ok i give up. spent an entire day trying to find my problem, and it just got worse.
i took out my dogbones as adviced, and still the problem persisted. so, i took out both my diffs and gave my bearings a good blast and a good lube after that.
assembled my entire car getting ready for practice tomorrow, and the binding became worse. even moving straight now, i get a little. when i turn, much worse it`s like braking harder than before
all linkages arn`t touching anything. chassis plate isn`t bent. bearings are all good. centre shaft isn`t binding. it`s definitely the front part cause, when i disassembled both diffs, back spins normally, but only the front binds.
is there a possibillity i tightened my front diff too much? cause i tightened my screws. not crazily tight, but , tight.
what could be the problem?