R/C Tech Forums - View Single Post - Motor Problems
Thread: Motor Problems
View Single Post
Old 09-07-2005, 08:59 AM
  #6  
CarlosG.
Tech Master
iTrader: (12)
 
CarlosG.'s Avatar
 
Join Date: Jul 2004
Location: Falls City,TX
Posts: 1,145
Trader Rating: 12 (100%+)
Default
The three copper plates where the brushes make contact to the commutator. check to see if you have continuity between each copper plate. If you don't between them, then you will not have full power use of the motor.
CarlosG. is offline  
Reply