Originally Posted by wolfman76
the instruction manual that comes with the charger says:
peak delay (nicd/nimh only):
The charger does not start the peak detection at the beginning of charge to prevent the charger from accidentally stopping too early.
- the adjustable range is 1 to 10 minutes.
so basically, it wont peak detect until after this time variable has passed.
mine is set to 4 mins, but i might change it to something higher for some of my more stubborn batteries that like to think they are charged when they definately arent..
motor run in feature.. mine said something about a connection error last time i used my lathe. i just unplugged and rechecked the connection to the lathe, and it worked fine...