Alright guys, I've got a question.
My rear sway bar seems to be acting unevenly. Both the cup side and ball side are perfectly flat. But for some reason, when I compress the suspension on the cup side(left side), the other suspension compresses a little more than when I do the same with the ball side(right side). I hope that makes sense.
What I ended up doing was rotating the cup side bar to about a 15 degree angle. This kept the reaction the same for the ball side while the cup side (left side) suspension is being compressed.
BUT, now when I compress the ball side(right side) suspension, the left suspension reacts the same as the right.
So basically now both sides react equally to opposite side suspension compression, but I have one bar level while the other is angled slightly.
My question is, is this the correct way to equalize the sides, or is there a better way to achieve this?
Thanks