R/C Tech Forums - View Single Post - Serpent 710
Thread: Serpent 710
View Single Post
Old 08-04-2005 | 01:01 PM
  #21940  
Julius's Avatar
Julius
Tech Master
 
Joined: Oct 2003
Posts: 1,063
From: Amsterdam Netherlands
Default

Use a diff. As loose on the clamp as possible. If you go too loose you'll notice the back end will slide under power. Too tight and you'll not have enough steering into the corners.

Use a higher rear roll center. Bottom top and top-inner-upper.
Also the body makes a lot of difference. I'd try a losi alfa or a stratus 3 as they are easier to get round small corners than a mazda.
Julius is offline