Originally Posted by fastharry
thats all well and good....but getting the engine to flame out..and then turning in 1/4 turn..and then running the WOT(..according to Josh's method)..does not yield temps in the 190 to 200 range.....
so maybe I should lean it out a tad..get the temp to 200..an then run it 3 tanks?....
This is what Rody Roem from RB Concept says for Break-In
Before you start to Break-in an engine on the bench,
I suggest you cover the cooling-head with something, so the engine heats-up properly FOR ONE TANK at idle (without the cover the engine will stay too cold).
Then start the engine and let it run rich at full throttle with or without the cover (depending on temp):
2-tanks at about 80°C.
Then 2 more tanks at 90°C.
Then 1 more tank at 100°C.
AFM