Originally Posted by theisgroup
with the pre updated software rx, it did happen a couple time on a 8 min run. once i got the update on the module and rx, it has never happened. also I did notice that even a slight tap of the board on the old software would put it in failsafe mode. since the update, I have not seen any problem with it.
I am not running a rx pack in my stock, but am running a 6v rx in my mod car. The mod car is running 9x2 and 10x2. both cars are running keyence zero v ext 2002 and ko 949ics in a helios transmitter. and both have been run indoors and out
Same here, My team mates have been using the Spektrum system for months now haven't experienced the problems Adrian described. I just got a system myself and it works fine with no servo pack. I've never heard of any software upgrades untill now. Do you know how to tell if a system is pre or post update?