Originally Posted by Randy Caster
Front
Speedtech spool
1.6mm swaybar
1mm offset steering block
4 degree hub carrier
1 degree camber
0 degree toe in/out
.3mm shim anti-dive
0mm spacers under susp. mounts
droop is 9.5mm measured from my setup board to the center of the hingepin, same as rear
4mm in front of arms
stock bladder and sponge
SSS body
Short shock end
62mm length
RS blue spring
450 shock oil
1.0 x 3 hole shock piston
1 o-ring bump stop
Bottom hole in hub carrier, shim on top of steering block
2'nd hole in on shock tower, middle hole on arm
0mm under camber link ballstud
4mm ride height
Rear
Direct pulley
1.4mm swaybar
.5 hub carrier
1.5 degee camber
2.5 degree toe block
0 degree skid angle
.5mm shims under both susp. mounts
Droop is same as front
4mm in rear of arms
stock bladder and sponge
62mm length
RS blue spring
450 shock oil
1.0 x 3 hole shock piston
1 bump stop o-ring
bottom hole in hub carrier
outside holes on tower and arm
0mm under camber link ballstud
4.3mm ride height
Checkpoint 7x1
SMC3300
LRP QC2
112 spur 25 pinion 8.96 final
Yokomo Stratus E Type Stock wing
Inner body mount
That was my Reedy setup (based off Masami's) I think Masami's was the same except they went with 2x1.0mm hole piston and a Mazda 6 body, looked like an aluminum front spool.