Originally Posted by DJB
i didnt get a chance to run it because there was no class because of the skool holidays
but it sounded alright on the power supply.
question about the comm tho, whats the approx number of runs you should use it before you cut it. It isnt geared too hard approx 46 pinion on a 96 tooth spur on a TB evo 3. i think thats about 5.42 im not sure. The comm in sections seems to be lightly black and then near the lines that are down the comm its much heavier. any reasons for this?? thanks
3~4 runs max with that motor before you need to cut the comm.... I would try a final drive 5.5 if you can.. or change to a 45t pinion gear
-Dave