Thread: Xray T1
View Single Post
Old 08-30-2002, 08:15 PM   #1584
Tech Master
stormperson's Avatar
Join Date: Sep 2001
Location: MA
Posts: 1,185
Trader Rating: 1 (100%+)
Send a message via AIM to stormperson

okay good, i am running the tensioner in the right place, lol.

i found though that it is too far to the driver's right, thus i placed a few shims to space it closer to the center, since the left of the belt was rubbing on the flange of the bearing in the stock position (unshimmed).

also i currently have figured out a nice carpet set up with the c-hub conversion (up front only though), incase anyone is interested, i have yet to race it, but it handles very well and in practice i have quite a bit of speed in the turns compaired to the other guys.
stormperson is offline   Reply With Quote