Originally Posted by rcfiend
BadBoyRC here's my setup
Frt
Spool
60 wt oil
Spring 22lbs
Caster 4 degree
Droop 5mm
Ride Height 5mm
Camber Link - all the way out bottom hole
Low roll center
No sway bars
Rear
40 wt oil
Springs 14.5lbs
Droop 5mm
Ride Height 5mm
Camber Link - all the way out bottom hole
Low roll center
No sway bars
Put the stock roll center blocks on. That will solve all your roll over problems. I've seen cars pick up over 1/2 a second a lap by taking them off. You could even go higher than stock.
Remember........ oil controls how fast the car rolls........ springs control how far the car rolls. Swaybars are like stiffer springs and help to carry corner speed, I ALWAYS recommend them. The low roll center blocks are just giving too much around corners.
Also, when you say your droop is 5mm. Is that the amount of up travel? I hope not as that would REALLY slow your car in the corners.
Jeff