I picked up the hard chassis this week and was planning on moving everything over and at the same time switching out to hex hardware. I picked up this 520pc 'RC screw kit' awhile back and realized I have most of the screws I need to do it already. Amazon's delivering the suspension pins today, so don't have to worry about those funky screws. So far, the only hold up are the 3x15mm screws that hold in the bumper plates.. I've got some 3x16mm, but is that extra mm going to be too much? Should I be safe and go pick up a few 3x15mm machine screws instead? Don't have any of those hex head screws either but eh those are only for the body posts and the front spindles so I can leave those I guess.

I was about to get started at like 6:30 this morning since I was awake but ran into that while I was looking through the manual and comparing what I had available heh. Didn't want to ruin my new $8 chassis haha.