Originally Posted by
keuk
Both are possible, you can use the original skeleton like on the Richard's carbon chassis, or updated / printed front/rear bulkheads. I have the 3D model for the structure too on with you can plug the original cover too. Can't wait to show you this when I will be able the upldoad pics.
Have we ever confirmed that the center diff front bearing issues were tied to factory assembly or a design issue? If you have the 3D models, you could conceivably add some meat to that area or allow for a larger race.
Additionally, was the cause of the center spurs being eaten resolved?
Just seems like if you are 3D printing, some past difficulties with the design could be overcome (if they are still issues)
I was hoping that after the kit came out, someone would chime in with their findings but such comments do not exist in this thread (that I have seen). Idea being that all the reported issues were due to factory assembly and that a kit would cure them all