VERY CLEAN RUN with my ProStock!!!
I measured my front tires and they were very low (19.9mm), but not quite paper thin. So I decided to try my standard tire setup, which is +1mm-19mm fronts with PN KS1138 tires taped with PN tape and +2mm-20mm rears with Marka V1R10 taped. I used Black 3D wheels with #8 disks on front/ none rear. The chassis is sitting higher than I normally run ( 2.2mm front 2.4mm rear), but I decided to try it and DAMN it was GOOD!!!! It has just a hint of TR, but I can still drive it hard. I will probably lower the front to see if I can get it all out, but it was almost easy to drive a 2.9xx second lap!
I also set up the steam humidifier in the room which has the humidity up to 70%, and I wet mopped the track with a microfiber towel on my Swiffer sweeper so I don't have to bend!
Anyway, here's the run, and if I can get the TR out, I can hopefully break 3:40!!!