Originally Posted by
Donnie26
As the title states I'm looking for something help and advice with my hobbywing xerun xr10 justock g3s. I went to check firmware using the LCD program box pro using the bluetooth function and saw there was an updated firmware. I went ahead and followed the promts on the screen and and everything seemed to go alright. After the update I wasn't able to access the esc via the program box and it came up with a message to update the database. So I went and did that which took a little time but seemed to work. Now when I power on the car the esc is doing single beeps repeatedly like it needs to be calibrated. I have steering but no throttle and I can't calibrate the endpoints on the esc. I can get into the parameters and make changes but I still can't calibrate the endpoints. Even when going back to the previous firmware on the esc and the program box i get the same result. The esc will beep and the motor will sometimes make small movements. The battery is fully charged so its not the LVC and I am able to get the program box to work fine on another hobbywing esc. Any help would be appreciated!!
try making sure all your radio adjustment for ESC are at 100. Also make sure your ESC is pugged in to the right channel on the receiver and plugged in with the correct orientation. I've heard of errors in firmware upgrades that occasionally happen during the update process that are usually resolved when the update is done using a PC vs a phone. Charlie has spoke about that on his podcast. If you used your phone to upgrade trying using a PC with the box instead. He said using the PC a lot of times will clear a wireless update error.