Originally Posted by
gigaplex
It doesn't change the rotor symmetry, the tool tells you if you have a good one or a dud. Moving the sensor board can slightly affect sensor alignment due to tolerances in the movement of the board.
Tuning for no load amp draw isn't a great method unless you already know what that particular motor performs well at. No load amp draw tells you nothing about loaded performance.
Funny you say that because one of my next videos will be me turning a motor while under a load. This is why I add the loaded numbers on my spreadsheets. Just about all the motors I tested worked best with a 5.5 amp load. However, the ORCA, i just tested, was just under 5 amps.