Originally Posted by Raman

He has the SRX not the standard kit. SRX uses different arms and has an optional piece you can add for droop.

Steps for ride height and droop as follow:
1. Set ride height with battery in car. Your target should be around 5.2 and 5.0 front. Best way to measure rear is at centre of back. Front, I usually remove the bumper so I can measure the front. On SRX, the screws go through the suspension holder. So you would have to reattach those in.

2. once right height is set, disconnect shocks.
3. If you have droop gauge, you place them under the chassis. If you don’t, you can measure from top of axle to surface.

For front, if your ride height it 5, you want droop at 6 mm. So you would screw in the adjusters till 6 mm is achieved.

rear if you set 5.2, you want droop around 5.7

This is a good starting point. After it’s set you can adjust after you do some laps. Making sure to do equal turns on left and right.