Originally Posted by J Tronzano
JRX-S Bill,
In your recent set-up post you mention adding 2 shims under front blocks.
Did you mean under both front/rear front inner blocks to increase roll center hight or just front pivot blk.?
JT,
Yep. You got it. As they came in the kit, one shim is .050" and the other is .035" for each stack under the front/rear blocks of the front end. However, Todd Hodge was initially using two (2) .050" shims in each stack for a total of .1".
Steve Weiss' setup for the Reedy has got to be a winner. Todd praised it, so I will likely try the variations of that setup too.
Bill