R/C Tech Forums - View Single Post - Tekno RC ET410 Thread
View Single Post
Old 12-16-2024 | 04:39 AM
  #1373  
Cain's Avatar
Cain
Tech Legend
iTrader: (304)
 
Joined: May 2002
Posts: 35,028
From: West Fargo, North Dakota
Default

Originally Posted by rustyus
HoBao has two different lengths of M3 shoulder screws/hinge pins that should work. It's been a while since I have measured.
#33335-1
#40014N


T-work's also has EB/ET410 front/rear specific hinge pins.
thanks! Will measure when mine comes in as I see people referencing them but not saying which they are using on the rear, which I am assuming is where the issue is mainly seen, correct?

Too bad on Exotek discontinuing that spur gear, that plate conversion is a nice touch so you can change the spur without opening up the diff
Cain is offline