So guys been running mini Z for quite a while now I run box stock, RM spec, AAA 3500, Kyosho 5600kv, and lip stock. I recently purchased a mr04, car is built on a pn 2.5 chassis with pn v4 frontend, and pn rear pod. Car bound up fine to my noble nb4 fine, steering works properly, but I have no throttle at all, the car has pn sensor wire and pn 3500kv motor installed. I wired the motor exactly as the directions stated. I don’t have any kyosho sensored motors so cant test with one, but I did pull motor out and tested with my gl 1.2 esc and motor works fine. Any help with this would be much appreciated. Or a direction to go for testing.

thanks