Hi all, I just got my car and have noticed that the kit setup "pushed" (understeered) throughout cornering at my local track. I have tried using Todd's asphalt setup , but unfortunately, I was not able to purchase the 10.5lb rear springs and the shims required to to go under the front roll centre (2 x 0.050" to make it 0.100"). I did however, make the BK bones and had them mounted on. My question is:
Does these two (2) variations from Todd's setup cause the car to handle like inconsistently when cornering? (cause the rear end to swap with the front end almost all of the time during hair pin turns) Also, the rear end just felt like it wasn't "locked in" (unstable).
The track conditions were: large medium grip track, 16'C ambient temperature, night racing.
Using 32 Sorex rubbers
Any help or advice would be greatly appreciated.