Originally Posted by nitro coffee

On the display, while charging, how come the amps displayed in the main section is different than the amp rate I set the charge to be? I notice this happens even more when Im using both channels to charge at the same time. If im only charging 1 channel then the amps in the main part of the display are close to the amp rate I set the charge to but sometimes its still lower. Its quite irritating to say the least. I have a huge power supply with a powerhouse charger and its not even charging at the 1-2c amp rates I set!!? I haven't changed anything drastic in the settings. Its pretty much factory settings. Is there something I can change or increase in the settings behind the scenes to always charge at what I set it to? Could it be the condition of the batteries affecting charge rate? Im shocked that this charger is undercharging the low amp rates 1-2c I set it to. Any ideas?