Originally Posted by
Rick Draper
Just testing a HW 17.5 G4R motor on a WMH load tester and I am at 44 degrees of timing at the test keeps failing on my HW tunalyser when mated up to the slave motor. It runs the test until the final 70% when it stalls. Any ideas what I can do to stop it failing? Is it a case of it having too much timing?
What motor are you using for your slave motor? Did I miss that?
If you watched my video on this motor, I almost had the same issue. The motor would hesitate with the low power test. The Fantom Helix RS was even worse. When it would hesitate, I would give the motor a bump with my finger. That would get it spinning again.
While running my tests, the G4R ran best with at 50*. However, not all motors are the same, but I'm sure they are not 6* off.
Like Trilerian said, you can use the 2RJ (2ohm) resistor, and that will put less of a load on the motor.