I recently ordered a custom iCharger DX6 charging case for a NANUK 915 because I use NANUK for my hard side DJI drone and camera cases. Rick was really helpful selecting the case size.

Notes

• Didn’t come with instructions and the link to instructions doesn’t work.
• The M3 machine screws might be a little short for NANUK, but seem to hold fine.
• The RL Power charger power cable has a long and super stiff heat shrink wrap on the XT90. The hole for the power cable could stand to be a couple mm further back.
• Not sure how other cases mount the power supply and charger, but this relies on heavy duty 3M Velcro.
• I had to solder the fan wires to the 4mm bullets on the charger power supply.
• I went with the mini RL Power to reduce weight.

Part list

• NANUK 915
• iCharger DX6
• RL Power XT90 Charger Power Cable
• RL Power Limited Edition MINI 70 AMP Power Supply