Originally Posted by
shortcut3d
I identified the issue with the R1 Wurks 13.5T. The insulation ring on the back of the stator between the solder tabs and end bell is loose and not glued.
Kudos to R1 Wurks customer service. Fast and easy replacement.
Did they send out a new stator? I actually asked them if they could just replace an insulator ring an their response was no. That design is not the best. I used some golf shaft epoxy I had laying around to epoxy mine back together. Don't get we wrong, R1 has some great spec motors, there are some areas that could use an update though.