Originally Posted by River19

I had the heat sink so I threw it on.....but yeah I don't expect much out of it and frankly at like $17 the motors are 100% disposable......that piece may stay off unless I need to balance the right side, but I doubt that will be needed as weight bias was a touch to the right anyways.

I will get the front lower but I am not going to work on that until I rebuild the steering rack, add the metal ball pivots to the front A-Arms etc. Once I get it all together I will work on lowering the front. I tested the bottom shock ball joint in the lower hole but that was WAY too low. I prefer to drop the front to 5mm and leave the back as is and see how it runs.

While I was able to drive the car competitively in last week's races in semi-drift mode, that isn't exactly what I am shooting for. A little slide is fine as long as it is predictable and not true under/oversteer.