Originally Posted by
BoxxerBoyDrew
I have thought about the MR04 very hard, but there are some questions I have that I can't seem to find the answers to. If anyone can help me I would GREATLY appreciate it!
1. Kyosho says it has new ICS software, so is it just a different program than the MR03 ICS, or is it a whole different USB plug in needed?
2. I have a PN V3 94/98mm pod and DDS system, will it fit? As my luck with the plastic pods isn't the best.
3. Kyosho talks about high speed steering, etc.. but they don't have a Noble EVO2 RX. SO will I get the benefit with the standard NB4 RX, and does it have problems with the "older" RX?
4. Are the sensored board/motor of the MR04 comparable in speed and power of the MR03 EVO with the same KV Motor?
Thanks for any Help! Drew
My experience so far with the MR04:
1. Same ICS adapter for the MR03 EVO works with the MR04 EVO2. Just a new version of the software is needed.
2. The T-Plate attachment area is the same as the MR03, so I think that'll work OK.
3. I use Futaba, so not sure on the Noble setup
4. The MR04 seems to lack a bit in the punchiness and top end as compared to the MR03 EVO, but it is smoother and I just put a bigger pinion on it to make up for it.