R/C Tech Forums - View Single Post - looking for advise
Thread: looking for advise
View Single Post
Old 02-13-2024 | 05:06 PM
  #5  
angrymelon's Avatar
angrymelon
Tech Master
iTrader: (1)
 
Joined: Aug 2008
Posts: 1,229
From: Portland, OR
Default
Originally Posted by OffRoadJunkie
You could, but I'm not sure if the leads are marked to indicate which point they are.
I don't think it matters for sensorless motors anyway. You would just have to swap the wires to make sure the motor is spinning in the correct direction.
angrymelon is offline  
Reply