Sanwa MT-R MT-S is this normal?
Always in past I had Futaba stuff! For each Rx was bound to model on Tx. If car lost signal between models car would be dead until TxRx was on.
This Sanwa isn't like that. On this MTR Tx, once a receiver is bound it will control any model no matter which model your using on Tx. If you have two Rx on in ea car at same time it will control both. Was told this is normal but surely not? It's like once Rx is binded. It's to full transmitter. Not just a model! Is this normal?
for example
I have ebuggy programmed to model 1. Truggy on model 3 and VRC Pro on model 4. VRC dongle kicks on even if I'm using model 1 or 20 even though it's set to model 4. It will work on any model It's like once receiver is binded to Tx it will work on any model which sucks. Especially when changing models when racing. Certainly think this isn't normal is it? I was told upper Sanwa models have safety links built into them but this MTR does not
HELP PLEASE
Last edited by jspeedracer88; 01-31-2024 at 01:26 PM.