Yes, all I care about is performance haha.

Looking at stock in this country, bodies that are looking good are the Blitz YRS-M and the Slidelogy D9. Of those I think the D9 is a more performance based shell whereas the YRS-M is focused towards the idea of running a FWD body on a FWD car. However, with the D9, I'm scared that perhaps the bulky front end of the M07 wont allow the body to clear at a more standard "race cut" trimming (as in scissor line on or even above the marked cut line). Does anyone know if this is the case?

I've been looking at the Xpress Mini Racer also. It is a 210 mm body but looking like 225 is quite achievable. Is that a fast body and can it be adapted to fit a 225 mm M07 (it's looking very sleek at the front as well)?

I could go to rcMart for a bit more variety but the shipping is so expensive from overseas.