R/C Tech Forums - View Single Post - Rotor Master
Thread: Rotor Master
View Single Post
Old 09-19-2023 | 07:56 PM
  #60  
gigaplex's Avatar
gigaplex
Tech Champion
iTrader: (2)
 
Joined: Dec 2015
Posts: 7,756
From: Melbourne, VIC
Default
Originally Posted by trilerian
I used an aluminum screw. But... I am going to make a modification to this. I am going to integrate a 3d printed part on the case itself not the rotor holder. But time...
Good idea to go off the case. Screwing into the rotor holder can potentially distort the plastic.
gigaplex is offline  
Reply