R/C Tech Forums - View Single Post - iCharger DX8
Thread: iCharger DX8
View Single Post
Old 08-22-2023 | 08:21 AM
  #118  
shortcut3d
Tech Addict
iTrader: (1)
 
Joined: Nov 2022
Posts: 559
From: PNW
Default
  1. Thank you. That's super helpful that storage will use the discharge setting profile if needed. So if my discharge uses and external resistor on Ch.2 at 32A then it will follow that setting. That's all I was trying to do.
  2. Just wanted to confirm. Voltage calculation should be based on the battery nominal voltage or the 12v of the PSU? I think it's the battery nominal voltage even if charging in series exceeds the 12V PSU.
  3. The DRC 2s Dual Balance charge lead looks like a series connection. So I think the voltage increase, capacity increases, and current remains the same; then you would end up charging at the same C? Thanks for the suggestion, I'll bump up my charging rate to 2-3C.
shortcut3d is offline  
Reply