Originally Posted by
Alexv2024
This is really cool. I'd build one but I dont want to buy whatever you need to flash stuff, unless its super cheap. Though if you flashed it I'd buy it and the PCB and assemble it myself.
Also I'd say you need to be able to measure rotors that get up to about 2200-2500 gauss, as stock is definitly headed there. I think some of the strongest 13mm mod rotors can get to 2000 if not 2200.
But you have a stack of PCBs, are you not planning on selling them at least?
Yes, I am going to sell these as well. I just made a for sale thread in the for sale forum. I don't really have a website for my stuff as of yet, so it is just here that I am listing them. On request I can make one that will measure up to 4000 gauss. however none of the current products on the market can measure over 1950 at the moment, so that is why I went with the sensors I did. I do have one build for me that will measure 4000 though.
As to a kit so to speak, maybe. I can burn the bootloader onto the mcu and put the sketch on it, but it really needs to be fine tuned after all the components are on the board. There are a lot of variables in my sketch that you change based on the quiescent output voltage of the sensors, the output of the 5v regulator, the "zero" output of the adc, and finally the multiplier to get your final gauss numbers.