R/C Tech Forums - View Single Post - RCHourglass DIY Lap Timing (AKA Cano revised)
Thread: RCHourglass DIY Lap Timing (AKA Cano revised)
View Single Post
Old 08-04-2023 | 02:57 PM
  #890  
Adam007
Tech Apprentice
 
Joined: Jun 2021
Posts: 96
From: Australia
Default
Originally Posted by mv4wd
Try to follow this, as written in the wiki: (rotate) the trimmer so that the measured DC voltage across the two loop inputs (without the loop connected) is zero.
You should see that the voltage reverts across zero when you turn the trimmer
Yes, adjusting the trimmer the lowest I can get is 1.2v
Adam007 is offline  
Reply