Originally Posted by
DeSousaB
I'm using this esc with a Rocket 4.5T motor and used the programming card to allow brake and reverse. The reverse isn't quite right thought - it seems to decide when it works after multiple brake/reverse action that works across my other RC's. (It's the ESC, I tells ya...!!!) In any event - any insights regarding what is awry would be much appreciated...
Note: First post. I am a newb...
This sometimes happens, you can try "calibrating" your ESC making sure your trims are zeroed out and your endpoints are maxed. Turn off any "brake" features your radio has, if any.
then carefully follow the ESC's calibration instructions.
You can also check to.make sure your "neutral range" is set correctly for your radio, generally you would set this percentage rated value higher for less expensive radios and lower for higher quality radios.
To do this try changing option 6 under A:General Settings, one step higher. Most times I've seen one or both of these steps causing your exact issue description.
Good luck, once you get your ESC dialed in you will thoroughly enjoy it!!!
PS: Your Programming Option C: Brake Settings can help dial in how your brakes work You want to set your Option C Settings somewhere close to the values in the first "Preset Value Column" labeled "MOD Class pre_setup.