R/C Tech Forums - View Single Post - Tamiya TT02 Thread
Thread: Tamiya TT02 Thread
View Single Post
Old 02-07-2023 | 05:43 PM
  #3506  
simple's Avatar
simple
Tech Master
iTrader: (2)
 
Joined: Dec 2008
Posts: 1,102
From: Windsor, Ontario, Canada
Default
Originally Posted by Silverbullet555
This is a brand new build so I figured I would started with the machine threaded screws like we on an AE or TLR car.

Is there a reason I should not?
Nope, go for it. I suggest however getting a “M3 forming tap”. Not a standard cutting tap. And pre thread the holes before assembly. It will virtually eliminate premature stripping of the holes, and make the whole assembly stronger. It’s a ton of extra effort, but it’s worth it.

Amazon M3 forming tap link
simple is offline  
Reply