Originally Posted by
edman4523
I want to setup a 20amp charging profile. When I enter 20 amps under setup it is giving me a warning. Am I doing something wrong or is it just telling me caution?
The caution shows up at 14.9 - 30 amps. I've only been charging at 9.6 amps. Just want to make sure all is good.
if I had to take a guess, it’s giving you the warning because of the capacity shut off you entered. It’s probably giving you a warning about charging above 3c. I’ve charged my 4800mah proteks at 20a without any warning messages, but I don’t have a cutoff capacity programmed.