R/C Tech Forums - View Single Post - Direct Power HV Servo
Thread: Direct Power HV Servo
View Single Post
Old 12-08-2022 | 09:28 PM
  #9  
Precision1's Avatar
Precision1
Tech Fanatic
iTrader: (54)
 
Joined: Jan 2012
Posts: 787
From: Southern Colorado
Default
Originally Posted by MXRCF1
I plan to use a similar servo to this but how do I take that 3s lipo voltage down so it does not fry the reciever? BEC?
If you do not power the RX from an ESC, then yes.
Put A BEC on the same leads that power the servo and bump it down and plug it into the RX.

I power the RX from the built in BEC of the ESC. There are only 2 wires going from servo to RX, a ground and a signal. No voltage.
Precision1 is offline  
Reply