Not sure if this is the best forum for this...but it is the closest fit that I saw.

With winter coming, I want to make an "evening and night" shell for my Slash 4x4 and kid number 1's Stampede 4x4. They will be dedicated shells because we beat the shit out of them during the day and I want to reduce knocking lights off, getting them wet, etc.

I got a bunch of LED lights. Several stick on style strips, a few white light bars, a fancy multi-colour one that has a small circuit board, some individual bulbs with holders, a bunch of y-splitters (including 2 with on/off switches, etc. I have some 9v battery cases coming in this week.

I want to avoid overloading the channels on the receiver box. I have 3-4 open channels there I think. I also don't know if the 9v battery holders will fit in there anywhere, I got them just in case.

I know this question depends a lot on specifics, but roughly speaking, how much output can a single channel on the receiver box handle? Can I "y-off" like 10 times and run a bunch of LEDs off it? Or do I have to limit my "y-off" to maybe 3 times, and use 3 different channels to get the same overall number of pigtails I can connect a light to (in which case I may get more switches). I'm just trying to get some idea of what i can do here. I mean, for all I know, I can't "y-off" more than once.

If I am just using a bunch of Amazon style lights, do I need that Traxxas high voltage BEC thing?

some of the lights I got are:

151mm LED Light Bar Roof Lamp Kit...


RC LED Light Bar Roof Lamp...


RC Crawler Light Bar Roof LED...


LED Light Strip for RC Fixed Wing...


ShareGoo 8Leds LED Light Headlights Taillight Kit Accessories Compatible with Traxxas HSP Tamiya Redcat RC4WD Axial SCX10 RC Car Truck Tank Crawler
https://a.co/d/32wwTPD

12 Volt 5Mm Pre Wired Led Light...


Red LED Light Kit for RPM Rear...