R/C Tech Forums - View Single Post - Making Tires with 3D Printed Molds
View Single Post
Old 09-10-2022, 04:04 PM
  #62  
RC10Nick
Tech Master
iTrader: (9)
 
RC10Nick's Avatar
 
Join Date: Oct 2010
Posts: 1,937
Trader Rating: 9 (100%+)
Default

I got a chance to try my latest pair of tires the same outdoor dirt track I tested the blue tires on. This time I tested this tire (my tire on the right, a JC DDv2 on the left for comparison):



Like I posted before, these tires weren't as soft as the blue tires I made last week and firmed up a bit more over the last few days. They felt more consistent and predictable around the track this time due to the smaller profile and closed cell insert, but they just didn't have as much grip as the JCs or even my blue tires from last week. I need to go softer for sure.
RC10Nick is offline