Was doing some tweaks on the rear axles:


I was about to doing a centered 3rd axle but I've offset the pumpkin 15mm to improve driveshaft angles. From reference photos, this model of Unimog axles are slight offset so no harm done



Modified the portal covers, making them stronger without messing much with the look. Printed 4 but did 2 more and upgraded also the front axle.







Middle axle:







Third axle






Because the offset diff of the third axle, had to do new unequal shafts










Middle axle with the driveshaft bearing carrier











Assembled...have to organize all the wiring again...