Originally posted by litespeed-dom
I own both. There is no comparison. The GFX simply just break the motor in, tell you the amp draw, you set the voltage and time, that's it. The only other thing you can do is to run a lathe.
The MM just pretty much does every of the above plus add a lot more features to it.
One more thing is that you can't adjust voltage while the GFX is breaking a motor in, but you can do that with the MM. For $160, it's a little bit spendy, but I got a used one for a little over $100, and it works perfectly so it's worth it in my mind.
The MM is just trick.
Dom
Thanks Dom for the Info, i am just looking for something more compact rather than my Turbo 35.
on another note Competion Electronics coming out with new firmware to fix motor Voltage adjust. E-mail them to get more information.
