Her we go guys. Today I spun up the first batch of steel flywheels. We tested to just over 20k rpm. These were designed with two set screws to allow for adjustable balancing but we still needed to spot drill some to dial them in. The price reflects that we are doing a small batch job. If any of you ever dealt with designing a part and the tooling and process to make it you will understand that the price we set is a bargain. Please help us out in recovering our investment. It would be appreciated if you step up and clean us out. At the price we don't start paying for time until we sell ten.
Here is the link
https://www.synergyhobbies.com/index...mRL4dFgEl1_Q20