Originally Posted by
wallacengineeri
Well I certainly don't bash like Kev does at all lol 🤣 way tok expensive to do that. However I did begin to slightly bend my old Kraton EXB (now sold) chassis over time. It took a while and some fairly large jumps to do so but it did eventually happen. Perhaps Ill hold off for now and see if M2C released a chassis for the Kronos XTR 2022.
By the way, I was referring to the new 2022 model, several people have already been them.
After reading your posts, it seems you are concerned about bending your chassis. It doesn’t really matter which truck you get, if you lawn dart it hard enough, your gonna bend the chassis. Some trucks come stock with slightly stronger/better chassis materials/bracing than others. All it takes is one bad lawn dart of a landing to bend ANY of them. Even an M2C chassis. The key is to just run what ya got, break it, fix it, and do it again!😎 The more you do it, the better you’ll get at it. I hate to say it, but the new Traxxas Sledge appears to have a very strong chassis setup. Only time will tell how good or bad it really is. I watched a YouTuber lawn dart it really hard several times in the same video. Afterwards it was checked with a straight edge and showed no bending.