Originally Posted by
DavidNERODease
I've been eyeball'n this chassis a lot and it's very interesting how much focus appears to be placed on flex characteristics. The main plate is 100% symmetrical (like for real)... the front pulley is offset to the right to allow the servo to be mounted dead centre with rear diff dead centre. Plus, if you are careful to mount your electronics so that they don't touch the outer chassis rail and do the same with the battery by placing pads in the machined areas, you could simulate a full floating electrics setup like the ones seen from RCMaker and Kyosho but without raising the CG as much.
Hmmm Symmetrical Flex .... thats a great idea lol.
If you move the slots in closer to the pod though you can actually benefit by freeing the drivetrain up a bit.
Virtually run the motor/spur plate flat helping keep the motor more static then dynamic as the chassis flexes.
Also material fatigue with the sides that close I think is gonna be a factor.
But Im not knocking the car at all, I still hope to see it bring new faces to some racing if they can keep it in the 3Racing type of pricing.