R/C Tech Forums - View Single Post - RCHourglass DIY Lap Timing (AKA Cano revised)
Thread: RCHourglass DIY Lap Timing (AKA Cano revised)
View Single Post
Old 01-15-2022 | 12:07 PM
  #770  
PA3EXV
Tech Apprentice
 
Joined: Jan 2013
Posts: 61
From: Schoonebeek
Default
Originally Posted by mv4wd
Follow the schematic of the decoder. It's not 15.2 and 15.3 ... it's 15.0 and 15.1
Owh....yes...now I see....You are correct of coarse (as designer)..
I was put the wrong direction because in some early post from other builders were pictures shown were the crystal was at the 15.2 and 15.3....See here below....


And also because the writing on the PSoC PCBA itself indicates the other 2.
I try now and let you know later this evening.

PA3EXV is offline  
Reply