Please advice:

I bought some PSoC kits this week. Installed the adviced Programmer from the Cypress site and tried to upload the latest .hex file.
All fine, no errors.
I attached a 5MHz crystal as well as the two 22pF's like in several diagrams is shown to 15.2 and 15.3
But when I connect the small USB connector to a 2nd USB port, the device manager doesn't show another COM-port.
I did NOT supply the PSoC by 5V at pin VDDIO, because I measured 4.8V DC at that pin already (=due to PC USB also being connected to the large USB pads).

I measured the 15.2 and 15.3 pin of the PSoC, but there is no oscillation found. Changed the crystal out for another one did not solve it.
What is going on here?? In Marco's post that shows the method, the programming takes 23 seconds, in my case just below 4.
It looks like the target is not programmed....is my setting in the Programming environment wrong somewhere?

My PSoC setup is at this moment thus as minimal as possible, only connected the 5Mhz crystal + cap's. Supply of the PSoC through the daughterboard.


Then I tried if I could program at all. so I did the project described here which indeed worked and my blue LED can blink: