Hi there
2 questions.
1. droop values
When looking at the std setup sheet, they say 2.5mm front and rear. Ohter set up sheets are also saying aroung 2.4 front and 2.2 rear. I find these values a bit strange. Chassis sitting flat on setup board and measurements have been done from setup board ground to the lowest point of the hub. With thes values I find the downstop travel a bit long. Or what do you think about?
2. setup for carpet
for other brands a lot of carpet std setup sheets are available, especially on petitrc site. For X20 '21 there almost sheets available for asphalt tracks. I know there are not a lot pro drivers who are racing this chassis. Maybe anyone can tell me a starting point for the X20 on carpet (alu flex, medium traction)?
Thank you all!