Originally Posted by
Quante
Ran 17.5 for the first time but I had to file away about 1mm of CFK from the lower pod plate in order to fit a 52t pinion with the 76t spur to get to 90mm rollout.
Luckily the pod plates had enough room to shift the motor in position...
How is the rest doing this??
I saw smaller spurs are available from kawada and I think Xenon but getting them wont be easy.
Same, I chucked a router burr style end mill in my drill and clearanced it.
I think imma design a pod plate for 17.5/21.5 guys soon. Got the material to toss on my mill. I couldn’t find a small enough spur in stock.