Hey guys, so I just was able to finally finish my first kit, a Team Associated RC10SC6.2, however after my first shakedown run I found that I had little to no brakes. If I hold the car in the air and give it throttle then apply brakes you can notice the brakes, but when its on the ground it hardly slows down. I'm running a Futaba 3PV with all the stock settings, a Reedy 1000z+pro, and the Reedy s-plus 13.5 motor. I've tried reprogramming the esc with the Programmer2 and turned all the brake settings to max, but there's been no change. If anyone could help that'd be greatly appreciated, Thank you